ESON 696Ui, User Manual, Page: 33 / 343

33
Setting Up the Projector
Follow the instructions in these sections to set up your projector for use.
Projector Placement
Removing and Attaching the Cable Cover
Projector Connections
Installing Batteries in the Remote Control
Installing Batteries in the Pens
Projector Placement
Your ultra-short throw projector is designed to be installed on a wall (with a wall mount) or vertically on a
table (with a table mount) to create an interactive tabletop workspace.
You can also place the projector on a flat surface such as a desk or table to project in a portable setup.
Note: Finger touch is only available if the projector is installed on a wall (with a wall mount) or vertically
on a table (with a table mount).
Keep these considerations in mind as you select a projector location:
• Follow the instructions in the Installation Guide provided with your mounting hardware to install the
projector using the included mounting equipment.
• Leave plenty of space around and under the projector for ventilation, and do not place it on top of or
next to anything that could block the vents.
• Position the projector within reach of a grounded electrical outlet or extension cord.
• If installing vertically on a desk or table, the table projection mount (V12H516020) is required.
• If installing on a wall, the wall mount (V12H777020) is required.
• If the projector is not mounted, place it on a sturdy, level surface.
• For finger touch, make sure the projection surface is flat, smooth, and unwarped with no more than 0.2
inch (5 mm) of unevenness in any direction.
Projector Setup and Installation Options
Projection Distance
Parent topic: Setting Up the Projector