56
1.
Connect one end of the cable to the
SYNC In
port on one projector, and connect the other end to the
SYNC Out
port on the other projector.
Note:
If you are connecting three or more projectors, connect the projectors in a chain as shown.
2.
In the Extended menu, set the
Sync of Projectors
setting to
Wired
.
Note:
If you are syncing multiple projectors with a combination of wired and infrared connections, set
the
Wired Sync Mode
setting to
Mode 2
in each projector's Extended menu. If you are syncing
using an infrared connection and the projectors are more than 6.6 feet (2 m) apart, set the
Distance
of Projectors
setting to
Mode 1
in each projector's Extended menu.
Parent topic:
Related references
Projector Setup Settings - Extended Menu
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector.
Summary of Contents for 696Ui
