KK-EPA.004 Rev No:0 28.09.18
29
On the FILTR option, you can specify the how many miliseconds later tare signal will be checked. By
default, this value is 100 ms.
7.1.3. Screen Refresh Rate (REFRS)
Indicates how many milliseconds the value displayed on the screen will be refreshed. By increasing this
value, which is 100 ms by default, you can avoid or reduce the unstability on the screen, reducing the time
it takes your device's sensor to react.
DISP
The new function you confirmed with the PRG button has been
set. You can return to run mode with the ESC button.
When you press and hold to the PRG key the value in the second
line starts blinking . You can select OFF, RISE or FALL functions
using the UP and DOWN buttons.
TARE
OFF
INPUT
EDGE
OFF
RISE
EDGE
RISE
DISP
The new filter value you confirmed with the PRG button has been
set. You can return to run mode with the ESC button.
When you press and hold to the PRG key the value in the second
line starts blinking. Enter the desired value using UP and DOWN
buttons.
TARE
100
FILTER
100
200
FILTER
200
DSP
Press and hold the PRG button.
REFRS
100
100
When you press and hold
to the PRG key the value
in the second line starts
blinking. Enter the
desired value using UP
and DOWN buttons.
110
REFRS
110
The new screen refresh rate you confirmed
with the PRG button has been set. You can
return to run mode with the ESC button.
Press and hold the PRG button.
Press and hold the PRG button.
INPUT
