Proper use of cooler
The arrangement of bottle
Pay attention when arranging:
Usage of temperature zones in R
As different temperature zones generated due to air circulation in the cooler:
The upper area's temperature is the highest while the lower area the lowest.
The arrangement of beverage
Different beverage can be stored from top to bottom as following sequence:
l
Strong red wine
l
Pink and mild red wine
l
White wine
l
Champagne and spritzer
We suggest to pour wine in temperature below serving temp, as the wine would warming up quickly when
pouring into tumbler.
5
Do not let bottle touch the R's back in order to maintain good air circulation in the cooler.
l
The bottle number here may be different from bottles in different shape and size.
l
As the compressor has taken the space, the lower area of cooler is relatively shallow, which can fit in
beverage cans or shorter bottles.
l
Placement
The cooler is placed in a well-
ventilated indoor place; the
ground shall be flat, and sturdy
(rotate left or right to adjust the
wheel for levelling if unstable).
Before using the cooler,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the cooler,
tear off the protective film
on the door and the cooler
body.
Avoid direct sunlight and heat
sources such as stove, heating
radiator, etc. If the cooler has
to be put next to hear source,
a suitable insulation board shall
be applied or keep the cooler
away from heat source by
following minimum distance:
Stove: 3cm.
Oil furnace or coal stove: 30cm
°
The hot air from side wall of
cooler shall be exhausted
unrestricted, or compressor's
power will increase and further
increase power consumption.
Thus the distance between
cooler and walls or neighboring
furniture shall not less than
4cm. It is also necessary to
maintain distance for doors to
open at least 90 .
The room for cooler shall become
larger with more refrigerant in
cooler, with 8g refrigerant
3
corresponding to 1m spaces.
The content standards of
refrigerant are labeled in name
board on backboard of cooler.
Start to use
The cooler shall stay for half an hour before connecting 220~240V/50Hz
power when it is firstly started.
Do not connect cooler to electronic energy saving plug and converter that can
convert DC into 220~240V AC (E.g.: solar energy system, ship grid).
Clean up the inner chamber before put into use for first time (Refer to cleaning).
Water drop or frost will be generated on R's back when compressor is functioning,
which is decided by function of cooler. Dispense wiping out frost or drop as the back
will wipe them out automatically. The defrosted water will be collected into drain tank,
then inflow into water disposal pan above the compressor and vaporized.
