ESI Kata Series, Installation Instructions Manual, Page: 7 / 12

Page 7
Kata Assembly
180°
motion
arm
180°
fixed
arm
front screw
rear screw
dual Allen key
2mm end
front
rear
monitor
not shown
underside
underside
recessed portion
recessed portion
Step #7: install lockout set screw(s), if desired
Default rotation of the fixed arm and motion arm is 360°. Installation of a lockout set screw limits rotation to 180°.
• To lockout rotation of the fixed arm, install a M4x9 set screw in the upper hole in the recessed portion of the monitor arm. Tighten the screw, then back it off one turn.
• To lockout rotation of the motion arm, install a M4x15 set screw in one of the two holes in the underside of the fixed arm. Tighten the set screw, then back it off one
turn.
— From the user’s perspective, when the fixed arm is to the left, you will install the M4x15 set screw in the front hole to create a 180
°
lockout. When the fixed arm is
to the right, you will install the M4x15 set screw in the rear hole to create a 180 ° lock out.
• The motion or fixed arm must be in its desired range of rotation when installing the lockout set screw. Only one motion arm lockout set screw may be installed.
M4x15
M4x15
M4x9