ESI ESRTPRF, User And Installation Instructions Manual, Page: 30 / 36

24
Installation
1. Loosen the screws on the back-plate and remove from
the Unit.
2. Fix the back-plate, terminals at the top, either direct
onto a flat wall using wall plugs and screws or on a flush
mounting single conduit box. Route the wires through the
back of the wall plate and fit the wires to the wall-plate in
accordance with the relevant diagram and in accordance
with I.E.E. regulations.
3. Fit the Unit onto back-plate, and tighten the screws.
4. Ensure an appropriate fuse is fitted to the circuit before
reconnecting to the mains supply.
Commissioning/ Configuring
1. If the receiver and thermostat have been supplied as a
kit, the units have already been paired in the factory and
no pairing is needed.
2. Power up the receiver and press M/A (Manual/Auto)
button ① (Fig.5, page 25) for approximately 10 seconds
until the MANUAL light ② (Fig.5, page 25) begins to
flash.
3. On the programmer, press and hold “SET” and then
“DAY” until the green light of receiver stops blinking (after
approximately after 10 seconds).
4. When the light on the receiver stops flashing the two
Fitting the Receiver