Art.No.11603-48
*
if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH 2021
www.esera.de
11603-48 V1.0 R1.1 Manual
Page 1 of 18
User Guide
ECO 208 PRO
Professional 1-Wire Controller
The ECO 208 PRO controller is a high-
performance 1-Wire interface of the 3rd generation
for sensors and actuators in the industrial and
telecommunication sector.
fully automatic integration of sensors* and
actuators*
WLAN and LAN Modbus TCP data interface
max. 20 Modbus data connections
OLED display
8x digital inputs
1 x relay output / alarm output
Plug and Play interface for up to 30 sensors (e.g.
temperature, humidity, air quality, gas sensors)
Web server for configuration, Debug and Firmware
updates
robust industrial design
extensive software support
power supply -48VDC
Auto-E-Connect Support Level I to III
Fast readout of all 1-Wire Devices in a
1-2 seconds cycle
Basic unit for many industrial and telecommunication solutions
Designed for small to large 1-Wire Networks
Management of all ESERA and many standard
1-Wire Modules and Chips
Note
Before starting the installation of the ECO 208 PRO and putting the unit into operation, read this
operating manual carefully to the end, especially the section on safety instructions.
All settings and configurations of the ECO 208 PRO are carried out with the software Config Tool 3.
You can find this software on the ESERA website. Please refer to the operating instructions for
Config Tool 3, which can be found within the Config Tool 3 software under the
"HELP/SUPPORT" tab.
