ESD VME - ASIO16, Manual

Page: 39 / 63

Software
2.2.2 Description of the Parameters in Particular
STATUS - feedbacks of the parameter handing-over (’STA-
TUS’ is of type ’read only’):
’OK’.................... parameter was handed over correctly.
’Invalid Codeword’...... the command could not be identified.
’Invalid Parameter’..... the parameter inserted by the user has
been inserted incorrectly or is not
implemented.
’End of Record Missing’. the command was not completed by a
<RETURN> or <;> (semicolon).
’Wrong Baudrate’........ the baudrate was inserted incorrectly.
’Telegramm-Link Missing’ the telegram mode was selected, but
the parameters ’HUNTBYTE’ and/or ’END-
BYTE’ were not handed over or were
handed over incorrectly.
’User-Link Missing’..... the telegram mode was selected, but
the user-specific procedures at IRQ
level are missing or are indicated in-
correctly.
BITS number of data bits
possible values: 5, 6, 7, 8
STOP number of stop bits
possible values: (0.5), 1, (1.5), 2
values in () are not to be supported any more
PARITY type of parity bit
-
NONE no parity bit
- ODD odd parity
- EVEN even parity
MODE setting mode of the serial interface
-
USER the interface accepts the connection
of a RTOS-UH user (log in possible via
Ctrl-A etc.)
- TERMINAL as USER, but without possibility of
log in
- I/O ASCII (7 bits) without support of
cursor characters and without Ctrl-A
- BINARY all characters allowed, no end identi-
fication
VME-ASIO16 Rev. 1.7 35