CAN-PCC Software Manual Rev. 1.4
5
2. Configuration of the Parallel Interface
It is important to check and possibly adapt the setting of the parallel interface of the PC. The
configuration of the interface depends on the PC and the BIOS used. The following description is
therefore only exemplatory:
1. Call the BIOS setup when booting the PC.
2. Check under 'Chip Set Features' that the 'Parallel Port Mode' is set as follows and adjust the setting
if necessary:
Permissible settings:
1. ‘Normal’ or ‘SPP’ (Standard Parallel Port)
2.
‘EPP’ (Enhanced Parallel Port)
The setting ‘EPP’ is better than ‘Normal’ or ‘SPP’.
Non-permissible settings:
1. ‘ECP’ (Extended Capability Port)
2. ‘ECP+EPP’
3. Finish setup by storing parameters
Parallel interfaces which are not on the motherboard, but on an additional I/O board can normally be
configurated by jumpers. In this case, please refer to the manual of the interface board.
Summary of Contents for CAN - PCC
