Adapter CAN-PCIeMini/402-DSUB9 and Adapter Cable
4. Adapter CAN-PCIeMini/402-DSUB9 and Adapter Cable
Figure 3:
CAN-PCIeMini-402-DSUB9
With the adapter CAN-PCIeMini-402-DSUB9 you can connect the CAN interfaces of the CAN-
PCIeMini/402-2(-FD) via DSUB9 connectors.
The adapter CAN-PCIeMini-CAN/402-DSUB9 is not contained in the scope of delivery of the CAN-
PCIeMini/402-2(-FD). See “Order Information”, page 29.
The adapter cable CAN-PCIeMini/402-Cable and two UNC 4-40 DSUB bolts are included in the
scope of delivery of CAN-PCIeMini/402-DSUB. The bolts are intended to be used with a front
panel!
NOTICE
Read chapter “Hardware Installation” on page 14, in particular step 8., before you start
with the installation of the CAN-PCIeMini-402-DSUB9!
4.1 Adapter View
DSUB9
Cable
connector Jumper
with cable
Figure 4:
Top layer with DSUB9 connector
Figure 5:
Bottom layer with jumper
and cable connector
4.2 CAN Termination Jumper
With the jumper the CAN termination of the connected CAN interface can be set internally.
The jumper is located on the bottom layer of the adapter (see Figure 5).
JumperJP400
Jumper set
Internal termination (120Ω) of the connected CAN net (CAN0 or CAN1)
Jumper not set
The connected CAN interface has to be terminated externally.
CAN-PCIeMini/402-2(-FD)
Hardware Manual • Doc. No.: C.2044.21/ Rev. 1.1
Page 11 of 30
