Hardware Installation
8.
If applicable mount the CAN-PCIeMini/402-DSUB9 adapters in your system. Use the
enclosed bolts to fix the adapter.
NOTICE
The adapters are intended to be used with a front panel with 0,8 mm to 1,2 mm
thickness! Don't mount the bolts into the DSUB without a front panel or additional
spacers like washers, because otherwise the bolt threat might damage the DSUB.
9.
Close the system's case again.
NOTICE
Please note that the CAN bus has to be terminated at both ends!
esd
offers special T-connectors and termination connectors for external termination.
Additionally the CAN_GND signal has to be connected to earth at
exactly one
point
in the CAN network. For details please read chapter “Correct Wiring of Electrically
Isolated CAN Networks”
9.
Connect the system to mains again (mains connector or fuse).
10. Switch on the system and the peripheral devices.
11. End of hardware installation.
12. Continue with the software installation as described in the manual ‘NTCAN-API, Installation
Guide’.
Page 14 of 30
Hardware Manual • Doc. No.: C.2044.21/ Rev. 1.1
CAN-PCIeMini/402-2(-FD)
