Locate a switched fuse
and tap into the hot leg.
Ground for power can
also be found on the Bose
amplifier case. Pull the
carpet back to expose the
fuse box. The interface
(Letter Code F on the
Installation Manual) will fit
in the cavity under the
Bose unit.
Note: the optional
amplified speaker will also
get power from this area.
Display Controller, Remote Mute / Volume Adjust, Amplified Speaker (Optional HV model),
Concealed Display (Optional HV model): All wires from these components will run from the
driver side. Feed the wires through the console to the passenger side where the interface is
located. The small opening in the console for the wires is located towards the rear of the
console. The space is large enough for all wires.
The
Display
Controller
(Code letter E on the installation manual) can be mounted on the lower dash to the right of
the steering wheel or buried under the dash or in the center console or anywhere on the HV
model after user preferences are
programmed if any. NOTE: If the
owner wants laser shifting enabled
this must be performed in
programming mode in the Bands
MOD selection by setting SHFT in
the LSR selection column after all
items are completely installed and
power is restored.
