![background image](http://html1.mh-extra.com/html/esco/40807/40807_instruction-manual_2426071006.webp)
6
1.800.352.9852 • [email protected] • www.esco.net
ESCO OTR Large O-Ring Installer Model #40807
INSTRUCTIONS:
(cont’d)
Bead Remover Connection
•
Connect the bead remover to the single effect command circuit, with
suitable control systems using the fittings provided.
•
The system must operate at a pressure no higher than 700 bar with
a flow rate no higher than 0.7 1/min.
How To Remove The Bead
•
Check that the arm is open and resting on the rim.
•
Rest the bead remover on the tire and push it under the rim.
•
Operate the pump: The bead remover will start to close the arm,
which will then lock the rim and hold the bead remover in place,
which will push into the tire and detach it from the rim.
•
When the rim has moved a few centimeters, insert a shim and then
remove pressure from the bead remover.
•
Reposition the bead remover at another point near the first and repeat
the operation.