FIREBALL REMOTE CONTROL GUIDE WD049-1-2
2/23/2007
6640 Intech Blvd. Suite 250 Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
o
1119 for the FB1 button
o
1120 for the FB2 button
o
1121 for the FB3 button
o
1122 for the FB4 button
The LED will again flash twice indicating the programming was successful.
Programming the CBL button for FireBall Transport Control
The transport buttons on the top right of the keyboard are programmed to operate the FireBall,
however, they are actually programmed onto the CBL source buttons.
WARNING!
DO NOT program the CBL source button to control any other devices. Doing so will prohibit
the use of the transport keys for controlling the FireBall.
The CBL button by default functions as the FB1 transport controls. This button “punches-thru”
to the swoop key so that both are enabled when either the Swoop (FB1, FB2, FB3, or FB4) or
the CBL button has been pressed. However, the CBL button is not available as a universal
source when it has been programmed as the FireBall transport source button.
The CBL button can be programmed to assign transport controls to either FB1, FB2, FB3, or
FB4. Follow these instructions to program the CBL button to operate the transport controls of
the FireBall:
Press CBL
Press & Hold the “Set” button on the keyboard until the LED flashes twice.
Slowly enter “997” using the number buttons on the keyboard. The LED will flash twice
again.
Press the “CH-” button on the left side of the keyboard. The LED will flash four times.
Press the CBL source button.
Press & Hold the “Set” button on the remote until the LED flashes twice.
Enter the CBL reset code which corresponds to the FB source being reset:
o
“1370” for FB1 transport controls
o
“1371” for FB2 transport controls
o
“1372” for FB3 transport controls
o
“1373” for FB4 transport controls
The LED will flash twice indicating the code was accepted.
If you accidentally reprogram the CBL source button, use the following steps to program the
CBL button back to control the FireBall transports:
Press CBL
Press & Hold the “Set” button on the keyboard until the LED flashes twice.
Slowly enter “997” using the number buttons on the keyboard. The LED will flash twice
again.
Press the “CH-” button on the left side of the keyboard. The LED will flash four times.
