7
EScale Samurai - Instruction Manual
13. Locate the three pieces of plywood for the
servo tray.
Assemble and glue as shown in the picture
opposite.
14. Test fi t the servo tray through the front
opening in the fuselage and slide back in to
position.
Adjust the fi t if necessary.
Remove the servo tray and test fi t the servos.
Drill the holes for the servo screws then
remove the servos from the tray..
15. Glue the servo tray into the fuselage using
general purpose silicon (as shown) or 15min
epoxy.
If you use epoxy, rough up the inside of
the fuselage with coarse sandpaper to aid
adhesion. Set aside until the epoxy sets.
If you use silicon, make neat fi llets of silicon
where the plywood meets the fuselage and
set aside overnight to allow the silicon to fully
cure.
16. Fit the servos in the servo tray with screws
provided by the servo manufacturer.
