11
EScale Samurai - Instruction Manual
29. Locate the position on the rudder for the
control horn and remove the fi lm using a new
blade.
Take great care not to cut into the balsa or
you will weaken the rudder and may cause it
to fail.
30. Glue in place using 15 minute epoxy or thick
CA.
Ensure servo is still centered.
REMEMBER to feed the keeper on prior to bending
the wire.
Mark where you want to bend the wire to acheive
a neutral position.
Bend at 90 degrees and trim to 7mm. Push wire
through the control horn and position the
keeper.
31. Connect the pushrod to the control horn using
the supplied clevis.
Remember to add a small piece of silicone
tube to the clevis to prevent it falling off in
fl ight.
32. Install the elevator control horn and connect
the pushrod to the control horn using the
supplied clevis.
Remember to add a small piece of silicone
tube to the clevis to prevent it falling off in
fl ight.
