Page:
6
User Manual:
REVERSING THE DOOR SWING:
Tools Required: Phillips head screwdriver, Flat blade screwdriver and Hexagonal spanner.
→
Start by ensuring the bar freezer is unplugged and empty.
→
Adjust the two levelling feet to their highest position.
→
To remove the door it is necessary to tilt the bar freezer backwards. Rest the freezer
against something solid to prevent it from slipping whilst removing the door.
→
All parts that are removed will be used when re-assembling the door hinge, so ensure
they are all kept safe .
→
DO NOT lay the bar freezer on its back or sides as this may damage the coolant system.
→
This is a two person proceedure.
1
.
Remove the plastic cover from the top door hinge.
2
.
Unscrew the three screws from the bottom bracket and remove the hinge bracket from
the opposite side and place aside.
3
.
Slide the freezer door down approximately 15cm and remove from the top hinge, lifting
the door away from the fridge.
4
.
Remove the two screws from the top bracket and replace the bracket using the same
screws on to the opposite side. Note: You will need to remove the plastic cover caps from
the opposite side first.
5
.
Slide the freezer door back into the top hinge, ensuring that it is the correct way up. Then
screw the bottom hinge bracket into place, securing the door in place.
6
.
Fit the plastic cover caps and ensure that the door is aligned both vertically and
horizontally, before tightening the bottom hinge. Re-adjust the levelling feet.
Operating Your Bar Freezer
TEMPERATURE CONTROL
→
Your fridge has one control for regulating the temperature. The temperature control is
located at the rear, near the compressor.
→
Depending on your room’s ambient temperature, you may need to adjust the temperature
setting to achieve your desired temperature.
→
The number on the thermostat dial does not directly represent the temperature. Instead,
the larger the number is, the lower the freezer interior temperature will be. Dial position
1-2 will set your freezer to approximately -12°C, 3-4 will set your freezer to approximately
-15°C, and dial position 5-6 will set it to approximately -20°C.
Note:
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5
minutes before Restarting the unit.
→
If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize between
adjustments. Your first use, you should set the thermostat to the maximum position of 6
for the first 24 to 48 hours, afterwhich you can set it to the setting that best suites your
needs.
NOISE FROM YOUR BAR FREEZER
→
You may notice that your bar fridge makes some unusual noises from time to time. Most
of these are perfectly normal, but you should be aware of them!
→
These noises are caused by the circulation of the refrigerant liquid in the cooling system.
This is not a fault and will not affect the performance of your unit and is common with all
modern fridges.
