Page:
5
User Manual:
Your Esatto Bar Freezer
Installation Instructions
BEFORE USING YOUR BAR FREEZER…
→
Remove the exterior and interior packing.
→
Before connecting the bar freezer to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
→
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION LOCATION:
→
When selecting a position for your bar freezer you should make sure that the floor is
level, and that the room is well ventilated with an average room temperature of between
16° and 35°.
→
Always avoid locating your bar freezer near a heat source, such as a heater.
→
Also avoid direct sunlight as it may increase the electrical consumption.
→
Extreme cold ambient temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation.
→
Do not drape the unit with any covering.
→
When installing the unit, ensure that 20 cm of free space is left at both sides, 15 cm at the
rear and 20 cm at the top of the unit. This will allow cold air to circulate around the wine
cooler and improve the efficiency of the cooling process.
→
The door can be hinged to open to the right or to the left, depending on what better suits
the location.
→
Please ensure there is adequate space for the door to fully open.
→
Adjust the two levelling feet to ensure that the bar freezer is horizontally and vertically
level.
Storage Basket
Storage Basket
Storage Basket
