Page:
5
User Manual:
Installation Instructions
BEFORE USING YOUR REFRIGERATOR
→
Remove the exterior and interior packing.
→
Before connecting the fridge to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
→
Clean the interior surface as per the cleaning instructions within this manual.
INSTALLATION LOCATION:
→
When selecting a position for your fridge you should make sure that the floor is level, and
that the room is well ventilated with an average room temperature of between 16° and
35°.
→
Always avoid locating your fridge near a heat source, such as a heater.
→
Also avoid direct sunlight as it may increase the electrical consumption.
→
Extreme cold ambient temperatures may also cause the unit not to perform properly.
This unit is not designed for use in a garage or outdoor installation.
→
Do not drape the unit with any covering.
→
When installing the unit, ensure that at least 50 cm of free space is left at both sides,
100 cm at the rear and 100 cm at the top of the unit. This will allow cold air to circulate
around the fridge and improve the efficiency of the cooling process.
→
Please ensure there is adequate space for the door to fully open.
→
Adjust the appliances levelling feet to ensure that the fridge is horizontally and vertically
level.
→
Ensure that the fridge is positioned well away from sources of heat such as radiators,
boilers and direct sunlight.
→
You should always have access to disconnect the fridge from it’s power supply at any
time, therefore give consideration to ensuring the power outlet is positioned correctly.
ELECTRICAL CONNECTION:
Before connecting your fridge to power, ensure that the voltage and frequency shown on the rating plate
corresponds with that of your power supply. The appliance must be earthed. The power supply cable
supplied is fitted with a 10 Amp plug for this purpose.
→
If the power supply cable supplied is in any way damaged or not provided with a contact
for earthing, please contact the manufacturer/distributor or a qualified electrician to
rectify. The manufacturer/distributor declines all responsibility if these safety precautions
have not been followed. This appliance complies with the E.E.C. Directives.
Caution!
Electrical work should only be carried out by a suitably qualified and licenced electrician.
Risk of electric shock, injury or death!
Important!
The wires in the mains lead are coloured in accordance with the following code:
→
Green & Yellow:
Earth
→
Brown:
Live/Active
→
Blue:
Neutral
