Esaote MyLabSigma elite, Getting Started, Page: 74 / 134

U S I N G M Y L A B
MyLab
- G E T T I N G S T A R T E D 5 - 2
WARNING
When installing
MyLab
, check that the power cable is not tightly bent, that
it can’t be squashed by a misplaced foot or by heavy objects.
WARNING
Place
MyLab
in a location allowing an easy unplug of
MyLab
from the mains
in case of need.
NOTE
Whenever
MyLab
has to be insulated from the mains, disconnect the cable
from the power outlet.
CAUTION
Do not turn
MyLab
off while working (for example saving data) or during the
initialization phase: the hard disk could be damaged by this operation.
CAUTION
MyLab
is a PC based device; data loss or driver damage may occur if the
device is turned off while working (for example saving data) or during the
initialization phase. Refer to the appropriate chapters of this manual for
detailed information on when and how to safely power the device off.
MyLab Controls
MyLab
controls are located on the Control Panel Assembly that includes the
control panel and the touch screen.
Control Panel Section
The control panel includes the main imaging controls: the exam control
buttons and knobs, and the trackball. The control module also allows to select
imaging modes, review and annotate images, perform measurements and
calculations.
Table 5-1: Exam Control Buttons
Button Description
EN D EXAM
Closes the current exam archiving the patient’s data and producing
a report on the exam. The device clears the stored data and shows
the Exam Start menu again.
ARC H IVE
Gives access, at any time, to the archived data.
C W
Activates the Continuous Wave Doppler (CW). At its pressure the
positioning cursor is activated as well.