A D D I T I O N A L I N F O R M A T I O N O N S A F E T Y
MyLab
- G E T T I N G S T A R T E D
2 - 7
GETTI
NG STARTED
Wireless Requirements
MyLab
is equipped with built-in wireless capability.
When wireless is active, the operator should make sure to stay at a minimum
distance of 20 cm from the rear of the equipment. If it is necessary to work
at a shorter distance, temporarily switch the wireless device off.
NOTE
The wireless capability has to be considered as an intentional RF (Radio
Frequency) transmitter as indicated by the symbol:
When the wireless is active,
MyLab
might interfere with other equipment.
SS
Refer to the “Safety and Standards” manual for further information on
restrictions for the use of wireless connections.
WARNING
The device is equipped with a standard Wireless LAN RF receiver and
transmitter module that uses the following frequencies:
The device may be interfered with by other equipment, even if that other
equipment complies with CISPR emission requirements.
Receiver/Transmitter Band
[MHz]
Modulation
Maximum Transmitter Power
[dBm]
2400 to 2483.5
DSSS and OFDM
20 (WLAN standard limit)
5150 to 5350
OFDM
30 (WLAN standard limit)
5470 to 5725
OFDM
30 (WLAN standard limit)
Summary of Contents for MyLabOmegaVET
