ESAB Origo M11 Feed 302, Instruction Manual

Page: 5 / 20

-- 5 --
bm36d1ea
3 INTRODUCTION
The Feed 302 wire feed unit with control panel M11 is
intended for MIG/MAG--welding together with step
controlled welding power sources.
They come in different variants, see the spare parts list on
page 13.
The wire feed units are sealed and contain two--wheel
drive wire feed mechanisms as well as control electronics.
They can be used together with wire on ESAB’s
MarathonPac
t
, or on wire bobbin (standard Ø 300 mm, accessory Ø 440 mm).
The wire feed unit can be installed either at the power source, suspended above the
workplace, on a support arm or on the floor with or without wheel set.
ESAB’s accessories for the product can be found on page 16 .
3.1 Equipment
The Feed 302 wire feed unit is supplied with:
S
Instruction manual
S
Stickers with recommended wear parts.
Instruction manuals in other languages can be downloaded from the website,
www.esab.com.
4 TECHNICAL DATA
Feed 302
Power supply 42 V 50 -- 60 Hz
Power requirement 150 VA
Motor current I
max
3.5 A
Settings data
Wire feed speed
Burnback time
Creep start
2/4 stroke 1.9--20.0 m/min
0--0.5 s
OFF or ON
2 stroke or 4 stroke
Welding gun connection EURO
Max. diameter wire bobbin 300 mm (*440mm)
Wire dimension 0.6--1.2 mm
Weight 14.3 kg
Dimensions (l x w x h) 690 x 275 x 420 mm
Shielding gas
max pressure
All types intended for MIG/MAG welding
5 bar
Coolant
max pressure
50% water / 50% glycol
5 bar
Permissible load at
35% duty cycle
400 A
Enclosure class
with wire bobin *440mm
IP23
IP2X
* Accessory, see page 16.
GB