ESAB Cutmaster 40 SL60 1Torch, Operating Manual, Page: 103 / 120

ESAB CUTMASTER 80
Manual 0-5396 PARTS LIST
6-1
SECTION 6: PARTS LISTS
6.01 Introduction
A. Parts List Breakdown
The parts list provide a breakdown of all replaceable components. The parts lists are arranged as follows:
Section "6.03 Power Supply Replacement"
Section "6.04 Replacement Power Supply Parts"
Section "6.05 Options and Accessories"
Section "6.06 Replacement Parts for Hand Torch"
Section "6.07 Replacement Parts - for Machine Torches with Unshielded Leads"
Section "6.08 Replacement Shielded Machine Torch Leads Assemblies"
Section "6.09 Torch Consumable Parts (SL60)"
Section "6.10 Torch Consumable Parts (SL100)"
NOTE!
Parts listed without item numbers are not shown, but may be ordered by the catalog num -
ber shown.
B. Returns
If a product must be returned for service, contact your distributor. Materials returned without proper authorization
will not be accepted.
6.02 Ordering Information
Order replacement parts by catalog number and complete description of the part or assembly, as listed in the parts
list for each type item. Also include the model and serial number of the power supply. Address all inquiries to your
authorized distributor.
6.03 Power Supply Replacement
The following items are included with the replacement power supply: work cable & clamp, input power cable, gas
pressure regulator / filter, and operating manual.
Qty Description Catalog #
1 ESAB Cutmaster
®
80 400V CE Power Supply
with 400/415VAC, 3 Phase, 50 Hz, with input power cable 0559313304
6.04 Replacement Power Supply Parts
Qty Description Catalog #
1 Regulator 9-0115*
1 Filter Assembly Replacement Element 9-0116
1 Input Power Cord for 208 / 230 V Power Supply 8-4384
1 Input Power Cord for 400 V Power Supply 9-0218
NOTE!
*9-0115 regulator, If the serial number of the power supply is prior to #05078755 then
kit number 9-0201 will be needed to replace not only the regulator (9-0115) but the logic
PCB as well. Another way to tell if the kit is needed is to see if the regulator has a small
diameter tube coming out of the bottom fitting. If there is a transducer and wire harness
instead of the tube, the kit is not needed.