ESAB CIGWELD WeldSkill 205AC/DC, Operating Manual

Page: 30 / 72

OPERATION 4-2 Manual 0-5555
2. 8 Pin Control Socket
The 8 pin receptacle is used to connect a trigger switch or remote control to the welding Power Source
circuitry:
To make connections, align keyway, insert plug, and rotate threaded collar fully clockwise. The socket
information is included in the event the supplied cable is not suitable and it is necessary to wire a plug
or cable to interface with the 8 pin receptacle.
A-11662
Figure 4-2: Remote Control Socket
Socket Pin Part Number / Description
1 Not used
2 Trigger Switch Input
3 Trigger Switch Input
4 Not used
5 Remote Control 5k ohm Potentiometers
Maximum
6 Remote Control 5k ohm Potentiometers
Minimum
7 Remote Control 5k ohm Potentiometer Wiper
8 Not used
Table 4-1: 8 Pin Interconnection Control Plug Configuration
3. Negative Welding Terminal
Negative Welding Terminal. 50mm2 Dinse Type. Welding current flows from the Power Source via heavy
duty bayonet type terminals. It is essential, however, that the male plug is inserted and turned securely
to achieve a sound electrical connection
!
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being
fused in the Dinse terminal.
4. Shielding Gas Outlet
The Shielding Gas Outlet located on the front panel is a 5/8-18 UNF female gas fitting and is utilised for
the connection of a suitable TIG Torch.