ESAB Cadd Tig 1500i TA34, Service Manual

Page: 46 / 50

S0740 800 186/E080826/P50
-- 46 --
ct34i1
Recommended fuse sizes and minimum cable area
Tig 1500i Tig 2200i/2200iw
TIG MMA TIG MMA
Mains voltage 230 V
¦
10 %,
1
μ
50/60 Hz
230 V
¦
10 %,
1
μ
50/60 Hz
230 V
¦
10 %,
1
μ
50/60 Hz
230 V
¦
10 %,
1
μ
50/60 Hz
Mains cable area mm
2
3G2.5 3G2.5 3G2.5 3G2.5
Phase current I
1eff
9.1 A 11.5 A 11.5 A 13.4 A
Fuse
anti--surge
type C MCB
16 A
13 A
16 A
13 A
16 A
16 A
16 A
16 A
NOTE! The mains cable areas and fuse sizes as shown above are in accordance with Swedish
regulations. Use the welding power source in accordance with the relevant national regulations.
OPERATION
General safety regulations for the handling of the equipment can be found in
the instruction manual. Read through before you start using the equipment!
Connections and control devices
1 Connection (+)
TIG: for return cable.
MMA:for welding cable or return cable.
7 Mains switch
2 Connection for the remote control unit 8 Mains cable
3 Control panel (see separate instruction
manual)
9 Connection for shiedling gas
4 Connection for the TIG--torch trigger switch 10 Connection BLUE, with ELP* for cooling
water from the cooling unit
5 Connection for gas to the TIG--torch 11 Connection RED for cooling water to the
cooling unit.
6 Connection (--) for TIG--torch
MMA: for return cable or welding cable
12 Refilling of cooling water
* ESAB Logic Pump, see ’Water connection’ below