-- 27 --
dha4d1ea
S
For single wire < 1.6 mm (D35)
Use the straightener (3), connector (1) D35 with contact tip
(2) (M12 thread), fine wire straightener (4) with guide tube
(6) and guide spiral, which is inserted in the guide tube (6).
S
Assemble the clamp (7) with guide tube (6) in the M12
hole on the standard straightener (3). The guide tube (6)
should bottom on the contact tip (2).
S
If necessary, cut the guide tube (6) to length so that the
feed roller (5) runs freely.
S
Assemble the fine wire straightener (4) on the upper side
of the clamp for the straightener (3).
S
Connect the cooling water and gas (MIG/MAG welding).
4.3
Refilling with flux powder
(submerged--arc welding)
S
Close the flux valve on the flux hopper.
S
Remove the cyclone on the flux recovery unit, if fitted.
S
Fill with flux powder.
NOTE!
The flux powder must be dry. Where possible avoid
using agglomerating flux powder outdoors and in damp environments.
S
Position the flux tube so that it does not become kinked.
S
Adjust the height of the flux nozzle above the weld so that the correct amount of
flux is delivered.
Flux coverage should be sufficient so that penetration of the arc does not occur.
4.4
Moving the automatic welding machine
This is easier if the wheels are disengaged, which can
be carried out by turning the knob A anti--clockwise.
4.5
Conversion of A2 TFE1 (Submerged--arc) to MIG/MAG welding
Assemble in accordance with the instructions accompanying the conversion kit.
4.6
Conversion of A2 TFE1 (submerged--arc welding) to
TWIN--ARC (twin--wire)
Assemble in accordance with the instructions accompanying the conversion kit.
GB
