JA06062019
U
-00147
6
Center Support Bar
Step 9:
Insert the
Center Support Bar (o)
into the upper top groove on the back of the frame with the bottom
end near the approximate center point of the frame and rotate it in at an angle so that both ends of the bar are
in alignment with the groove.
Diagonal Sizes of 150” and below use 1 x Center Support Bar
Attention: Do not proceed with the Edge Trim installation until making sure there are no ripples in the material.
How to avoid getting ripples on the screen’s material surface
Solution:
Pull and smooth out the material using your hand from the center to the corners, creating a nicely
taut surface as shown below
.
Edge Trim Installation
ATTENTION: ON THE BACK OF THE MATERIAL THERE ARE LABELS INDICATING THE TOP
AND BOTTOM. THE TOP EDGE TRIM PIECE WITH THE LOGO SHOULD BE INSTALLED ON THE
TOP. THE MATERIAL IS DIRECTIONAL SO IT WILL NOT PROPERLY REFLECT IF THE BOTTOM
SIDE IS PROJECTED ON.
Step 10
: Place the edge trim frame pieces over each end of the frame.
p.
