OPERATING INSTRUCTIONS, MAINTENANCE & SAFETY
Cutters are precision tools made by master
creaftsman.
In order to maintain this precision and the
adjustments which are essential to satisfactory
operation of your cutter, it is important to
conscientiously follow these instructions.
1. In General
Handle cutter with great care. Do not drop it or
handle it roughly as this will change its
adjustments and may cause serious damage
mechanism.
2. Prior to Starting the Cutting Operation
Firstly set the “ON/OFF” switch to the “off”
position, connect the female plug of the electric
cord with the machine terminal and then tighten
the screw on the female lug. Now connect the
male plug of the electric cord to the electrical
outlet. Prior to starting the cutting operation
remove any obstacle from the path of the base
plate.
3. Cutting Operation
Do not force cutter through material. By nature of
their texture and because of the properties of their
fibers, not all materials can be cut with the same
speed or ease. Trail cutting will readily let you
find the best speed at which the machine is to be
advanced through the material.
4. Sharpening the Blade
1. Connect the plug of the electric cord to the
Power supply.
2. Push the switch to start the machine.
3. Pressing the Push Knob (#21) down for a few
seconds so that the sharpening stone lightly
touches and grinds the blade several times.
5. How to replace Blade
1. Make sure the electrical cord is disconnected
from power source.
2. Turn the screw for finger guard (#4) and
remove finger guard (#5).
3. Remove the blade lock nut (#1) by turning it
(#61,28,29,30).
4. Remove blade (#27) clean and dust or dirt
from machine.
5. Replace dirt blade.
6. How to Replace Carbon Brush
1. While the machine is unplugged.
Remove the two screw (#57) &
pull the cover (#54) upward.
2. Remove the screw cap (#49)
Over the carbon brush and re-
place the carbon brush (#50-1).
3. Put the cover (#54) back into its
original position and tighten the
screw.
4. Check the right and left carbon
brushes from time to time and
always replace both right and left
carbon brushes when worn out.
7. Lubrication and Maintenance
1. Turn the grease cup (#7) clockwise a
little bit to inject the grease into gear
box.
2. Make sure to add grease supplied
with the machine to the grease cup
(#6) when the grease cup is screwed
down to clean the bottom.
3. Always keep the machine clean
and free from remnants.
8. Maintenance and Inspection
1. Keep machine clean by removing all
accumulations of lint, thread and
cuttings from around the knife itself
to clean away from behind it, any
accumulated matter.
2. In addition, add grease to the
grease cup monthly using the
special grease the is supplied
with the machine.
3. From time to time, check the
right and left carbon brushes
and replace when necessary.
4. It is recommended that the
machine be turned off when not in
use.
5. Never put your hands in front of the
blade when operating.
6. Before doing any work on the
machine, be sure to disconnect the
machine from the electrical
outlet.
MB110-115V
600 rpms
