Important Safety Instructions
1.For toxic vapors produced by spraying certain materials can create intoxication
and serious damage to health. Always wear safety glasses, gloves and respirator
to prevent the toxic vapor hazard, solvent and pointing paint coming into contact
your eyes or skin. (see fig 1)
2.Never use oxygen, combustible or any other bottle gas as a power source or
would cause explosion and serious personal injury. (see fig 2)
3.Fluid and solvent can be highly flammable or combustible. Pls Use the tool only in
well-ventilated area, and avoid any ignition sources, such as smoking, open
flames and decrial hazard. (see fig 3)
4.Disconnect tool from air supply hose before doing tool maintenance and during
non-operation, for emerge stop and prevention of unintended operation, a ball
valve near the gun to air supply is recommend.
5.Use clean, dry and regulate compressed air rated at 3.0-4.0bar, never exceed
maximum permissive operating pressure 8.3bar (120psi)
(see fig 4)
6.Never use homogenate hydrocarbon solvent, which can chemically react with
aluminum and zinc parts and chemically compatible with Alum. and zinc pats.
7.Never point gun at you and others at any time.
8.Before operating the tool, make sure all the screws & caps are securely
tightened in case of leaking;
9. Before painting, make inspection for free movement of trigger and nozzle to insure tool can operate
well.
10.Never modify this tool for any other applications. Only use parts, nozzles and accessories
recommended and accessories recommended by manufactures.
Instructions For Operation
Preparation
1. After unpacking the product, inspect carefully for any damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before putting unit into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer’s instructions. Most
materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING
DO NOT EXCEED Maximum Pressure of Spray Gun or any other parts in the compressor system.
5. After Connect the gun to air supply, please make sure that the fluid cap, container and air hose have
been connected tightly with spray gun.
6. Set up a piece of cardboard or other scrap material to use as a target and adjust for best spray
pattern.
WARNING
Never aim or spray at yourself or anybody else which would cause serious injury.
7. Test the consistency of the material by making a few strokes on a cardboard target. If material still
appears too thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint
manufacturer’s thinning recommendations.
1
2
3
4
