1Touch
®
switch - Quick Manual
1Touch
®
switch Quick Manual P/N 121693
REV A
5-19-2011
WIRING
The 1Touch has one 6-pin Deutsch connector.
Mating connector:
Deutsch DT06-6S
Mating sockets:
Deutsch 0462-201-16141
Gold mating sockets:
Deutsch 0462-201-1631 (* for CAN connections)
Recommended wire gage:
16-20 AWG
Wedge lock:
W6S
PIN
CIRCUIT
DESCRIPTION
1
SYS POWER
(INPUT)
– battery voltage (+9VDC…+32VDC)
2
SYS GROUND
(INPUT)
– battery ground
3 DIM
INPUT
(INPUT)
– Configurable, analog or digital
(ground to battery voltage)
4
CAN HIGH
(DATA)
– SAE J1939 CAN 2.0B, 250Kbits/s *
5
CAN LOW
(DATA)
– SAE J1939 CAN 2.0B, 250Kbits/s *
6
CAN SHIELD
(DATA)
– SAE J1939 CAN 2.0B, 250Kbits/s *
SWITCH CAP INSTALLATION
The 1Touch switch caps and labels are easily installed with no
special tools required.
The switch labels must be custom created. Consult the full manual
for detailed information about the label.
1. Adhere the switch label
to the rubber switch pad.
Take special care to
place the label with
proper orientation.
2. Place one corner of the
switch cap into the corner
of the switch opening.
3. Press the switch cap’s other
corner firmly into place using
finger pressure.
ENABLING PASSWORDS
If more than
60
seconds has elapsed since the 1Touch switch was
powered you must enter the
ENABLE
password:
1101 1011.
The panel’s switch backlighting will blink once to indicate the
password has been accepted. Standard password entry is now
enabled for the next
60
seconds.
ADDRESSING
The 1Touch switch’s address may be set by entering the following
password:
1001 0010.
Switches 0 and 1 are now lit and all other switches are OFF. The
red LED bar graph indicates the current address (see graphic
below).
Press switch 1 to
decrease
the address value. Press switch 0 to
increase
the address value.
Press any other switch to save the address and resume normal
operation.
LOADING DEFAULTS
To load the 1Touch’s defaults, enter the password:
1001 1001.
This sets all of the switch types to bi-stable, address to 0, device
type set to 5, initial power states to OFF, LED indicator controlled
internally, and network mode set to ES-Key.
