STEP 1
STEP 2
STEP 3
In order to protect your flooring or carpet from
damage or stains it is suggested that you assem-
ble your tractor-cycle in the lid of the shipping
carton. To begin assembly, lay the tractor body
on its side over one wall of carton lid, as shown.
Place steering wheel onto steering shaft. Align
hole in steering shaft with those in steering wheel
and insert 10-24 x 1
1
/
4
"
screw through holes.
Thread 10-24 Kepnut onto screw and tighten.
Place seat into the desired position on seat base
of tractor body, (this can be further adjusted to
suit child after final assembly). Align holes in seat
with desired hole in body and tap the
1
/
4
-20 x 3"
screw through the holes with a cross screwdriver.
Thread
1
/
4
-20 Kepnut on and tighten.
10-24 x 1
1
/
4
"
Screw
and Kepnut
Steering wheel
Tractor
body
1
/
4
-20 x 3
" Screw
and Kepnut
Seat
Carton lid
Assemble
pedals to
pedal crank arm.
Slip
3
/
4
"
washer
onto one end of
pedal crank. Slip
pedal onto crank
with circular
recess at top.
Place capnut into
position and
proceed to
Subassembly B.
A
Place pedal
crank over
edge of workbench
or table, as shown.
Using the capnut
driver supplied,
hammer capnut onto
end of pedal crank.
Repeat Subassemb-
lies A and B.
B
Capnut
Capnut
driver
Screws pass through
backing plate here
Pedal slot
10-24 x
3
/
4
" Screws (2 per side,
each back with 10-24 Kepnut)
Squared end
of axle shaft
Rear axle slot
Pedal
Pedal
crank arm
3
/
4
"
Washer
Turn tractor over in carton lid so that it rests on seat
and steering wheel. Remove chain from its protective
carton (careful, it’s a bit greasy), drape chain over
assembled pedal crank arm as shown, and feed chain
through “chain tunnel” of body toward rear of tractor,
finally resting pedal crank arm in pedal slot. Reaching
into rear chain access hole of body, lift end of chain out
of body. Pass rear axle through loop of chain; squared
end of rear axle shaft must be on left side of tractor
when upside down (see illustration). Place rear axle in
rear axle slot of body. Pass 10-24 x
3
/
4
"
screws through
body and pedal bearing backing plate, trapping pedal
bearing into cupped recess in body; thread 10-24
Kepnuts onto bolts and tighten. Slide assembled axle
housing (from Subassembly Step 2) over one end of
axle. One at a time, pass
1
/
4
-20 x
3
/
4
" bolts through
holes in housing and body (this is easier with housing
in full forward position). Thread nuts onto bolts – DO
NOT TIGHTEN. Repeat this assembly for other side.
To adjust chain tension, grab rear axle with fingers on
both sides of gear, pull chain back so that chain is
snug. While holding gear in this position, tighten one
bolt on each side to hold axle in place, then tighten
remainder of bolts. Rotate pedal to check operation
and oil chain liberally while rotating.
1
/
4
-20 Kepnuts
(3 per side)
1
/
4
-20 x
3
/
4
" Bolts
(3 per side)
2
