8
USER’S MOUNTING INSTRUCTIONS
7. Connect the hydraulic quick couplers from
the attachment to the loader.
IMPORTANT:
Make sure the quick couplers
are fully engaged. If the quick couplers do
not fully engage, check to see that the
couplers are the same size and brand. Do
not force the quick couplers together.
IMPORTANT:
Wipe the ends of the
hydraulic quick couplers (both lead and
loader) with a rag to remove any possible
contamination. Contamination can cause
hydraulic components to fail and is not
covered under warranty.
NOTE:
See the loader’s operator’s manual.
NOTE:
Attachment is shipped with 8FJX
(3/4” Female JIC Swivel) fittings on the ends
of the lead hoses.
8. Make sure the hoses are properly routed to
fit your specific loader. If the hoses are not
routed correctly, hoses may get pinched or
rub on tires. Be sure to check the hose
routing through the full range of intended
motion of the attachment before operating it.
More than one routing may be acceptable
depending on the loader. Pick the routing
that best suits your loader.
IMPORTANT:
Proper hose routing is the
responsibility of the owner and/or operator.
Pinched or stretched hoses are not covered
under warranty.
NOTE:
Make sure the pressurized hose
from the skid steer is routed to the “P” port
of the valve block. If not the attachment will
not operate properly.
Mounting is now complete and you are ready to
use the attachment. Use the above instructions
in a reverse order to dismount the attachment
from the loader.
