11
E289L
SW2 functions during programming (DIP1 = ON)
DIP1=ON:
programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON
: open/close programming
DIP1=ON and DIP4=ON
: radio code programming
Radio code programming (only with RSD receiver)
1
Connect the electrical power
supply and close the barrier by
keeping PUL1 pressed down.
2
Select the code in the transmitter.
3
Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming
mode enabled.
R289A
R289C
R289B
4
Press the button for the required
channel. DL2 flashes to show
programming is complete.
5
Place DIP1 and DIP4 in OFF.
DL3 remains off.
6
Disconnect and reconnect the
electrical power supply.
I
II
R289D
R289E
If a receiver other than RSD is used, see the corresponding instructions.
Open/close programming
1
Connect the electrical power supply
and close the barrier by keeping
PUL1 pressed down.
2
Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3 lights up to show
programming mode enabled.
3
Press ST1 to start opening.
R289A
G289Z
G289A
The barrier is supplied with
open/close settings
programmed at factory.
4
Wait for it to come to a stop at the
end of its travel.
5
Press ST1 to start closing.
6
Wait for it to come to a stop at the
end of its travel.
G289C
G289D
G289F
7
Place DIP1 and DIP2 in OFF. DL3
remains off.
R289E
