11
Total opening radio code programming (with RSD receiver only)
1
Connect the power supply and
close the gate with DIP1 in ON
position and keeping ST2 pressed
down.
2
Select the code in the transmitter.
3
Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming
mode enabled.
R268A
ST2
R268C
R268B
SW1
4
Press the button of the required channel.
DL2 flashes when programming is complete.
5
Place DIP1 and DIP4 in OFF.
DL3 remains off.
6
Disconnect and reconnect the
electrical power supply.
Programming is carried out in the
same way, using DIP6 instead of DIP4.
R268D
R268E
SW1
Pedestrian opening radio
code
Z
If a receiver other than RSD is used, see the corresponding instructions.
Total open/close programming
1
Connect the power supply and close
the gate with DIP1 in ON position
and keeping ST2 pressed down.
2
Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3 lights up to show
programming mode enabled.
R268A
ST2
G268Z
SW1
3
Press ST1 to start opening.
4
Press ST1 to start slowdown.
5
Wait for it to come to a stop at the
end of travel.
G268A
ST1
G268B
ST1
6
Press ST1 to start closing.
7
Press ST1 to start slowdown.
8
Wait for it to come to a stop at the
end of travel.
G268D
ST1
G268E
ST1
9
Place DIP1 and DIP2 in OFF. DL3
remains off.
R268E
SW1
Pedestrian open/close programming
This is carried out in the same way as total travel
programming, with the following differences:
•
DIP1 and DIP3 are used instead of DIP1 and DIP2
•
ST2 is used instead of ST1
•
In step 5, stop the gate with ST2
