Pag. 16
Relay configuration ( Relay1 and Relay 2)
The operating mode of the two relays can be set in
separate way.
Each relay can be configured as follows:
!
PULSE
-
Pulse operating mode
: the relay excites at
the reception of a good transmitter signal and remains
excited until the transmitter key is released.
!
STEP -
Bistable operating mode
: the relays excites at
the first pulse and releases at the next one
!
TIMED 6 SECONDS -
Timed operating mode:
at the end of the received signal the relay remains
excited for further 6 seconds.
!
SHORT RANGE -
“Pedestrial operating mode” :
in
this case the receiver sensitivity is reduced of 40 dB
causing a big reduction of the radiocontrol range
( Final range of about max 10 mt.)
Structure of the sub-menu
YES
YES
NO
NO
MENU
CONFIG RECEIVER ?
CONFIG RECEIVER
RELAY:1 ?
RELAY:1
STEP ?
RELAY:1
PULSE ?
RELAY:1
TIMED 6 SECONDS
RELAY:1
SHORT RANGE
NO
NO
Select the RELAY 1 or RELAY 2 configuration using the
LEFT Key of the MASTER transmitter and confirm with the
RIGHT key : the display will give the message:
EXECUTED OK and the program will return to the main
menu.
Facility Code set-up
The “Facility Code “ (FC) is a number, in the range :
“000” to “256”, sent by the transmitter with its own Serial
Number (S/N).
The receiver is programmed to accept only transmitters
which have 2 types of Facility Codes.
Any transmitter with facility code different from the 2
programmed won’t be accepted.
Through the following procedure it is possible to set the
couple of Facility Codes.
Select the option : FACILITY CODE : 1? from the
receiver configuration menu using the LEFT key of the
MASTER transmitter..
Confirm the choice and you will be asked for the new
Facility Code.
The message prompts with the current number
memorized for the Facility Code 1
F A C I L I T Y C O D E : 1
C H E C K F O R
0 0 1
You are asked to change or confirm the memory settings.
In the case above, the receiver accepts only transmitters
with Facility code = 001.
Config the Facility Code making use of the MASTER
transmitter, or the KEYPAD or by using the key B of a
transmitter with the desired Facility code.
At the end appears the message:
EXECUTED OK
and
the program return to the main menu.
The procedure to set the Facility Code 2 is similar to the
other.
On the display will appear “Facility Code 2”.
F A C I L I T Y C O D E : 2
C H E C K F O R
0 0 1
NOTE
: the Facility code Null ( “000”) has a special
meaning.
In this case the Facility Code check is completely
disabled.
