R A D I O C O M A N D I
7
5.4 MEMORY ERASE
5.4.1Using the radio control
(A+B)4 - [Bip] A4 [Biiiiiiiiiiiiiiiiiip ] - (A+B)4 [Biiiip ],[Biiiip ],[Biiiip ].
ATTENTION: DO THIS OPERATION WITHOUT SLIDING OUT THE ELECTRONIC
CARD FROM THE BOX !!.
OPERATE EXCLUSIVELY FROM OUTSIDE !.
5.5 TIME OUT SETTING
(A+B)4 [Bip], D4 [Biiip - Biiip - Biiip - Biiip] and following:
A1 [Biiip] :
for time-out of 40 Sec.
B1 [Biiip, Biiip] :
for time-out of 90 Sec. (default value)
C1 [Biiip, Biiip, Biiip] :
for time-out of 180 Sec.
The time out setting allows to stop the motor in case of failure of the limit switches.
This operation has to be done by using the transmitter according the following sequence:
5.4.2 -Using the reset push - button
Make a pressure on the button of the plastic box of the radio programmer up to the biiiiiiiiiiip of
the buzzer.
In this way the reset push button present on the bottom side of the electronic card is activated.
Afterword release and within 2 seconds push again the button of the box up to listen 3 long
biiiiiips of the buzzer which give the cancelling confirmation.
90 sec
.
180 sec
.
40 sec
.
Fig. 11
Fig. 12
