5
GB
Safety Information / Use
Safety Instructions
for Batteries
J
Remove the batteries from the device if they are
not going to be used for a prolonged period.
J
CAUTION! DANGER OF EX-
PLOSION!
The batteries must never
be recharged!
J
When inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
J
If necessary, clean the batteries and device
contacts before inserting the batteries.
J
Remove spent batteries immediately from the
device. There is an increased danger of leaks!
J
Batteries must not be disposed of in the normal
domestic waste!
J
Every consumer is legally obliged to dispose of
batteries in the proper manner!
J
Keep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
J
If the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
J
Avoid contact with the skin, eyes and mucous
membranes. Any parts of the body coming into
contact with battery acid should be rinsed off
with copious amounts of water and / or a doc-
tor contacted if necessary!
Q
Use
Q
Insert Batteries / Filling of the
salt and pepper mill
Indication:
The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the lower section with container
6
firmly
and turn the upper section
1
in an anticlock-
wise direction (see Figure A) until the arrow on
the top
1
is aligned with the arrow on the
base with container
6
.
2. Now please pull the top
1
off the base with
container
6
.
3. Pull the motor
3
carefully off the base with
container
6
.
4. Pull the battery ring
7
off the motor
3
.
5. Insert 4 new batteries type AA 1.5 V
(R6).
Indication:
Pay attention to the right polarity.
This is shown in the battery compartment.
6. Place the battery ring
7
back on to the motor
3
.
7. Fill up the base with container
6
with pepper-
corns or coarse salt. The best result will be
achieved when filling the base with container
6
up to 75 %.
8. Put the motor
3
back on the base with con-
tainer
6
.
Indication:
Please make sure that the con-
tacts
4
,
5
face each other (see fig. A).
9. Put the top
1
back on the base with container
6
.
10. Hold the base with container
6
firmly and
turn the top
1
in a clockwise direction (see
fig. B) until the arrow on the upper section
1
is aligned with the arrow on the base with con-
tainer
6
.
Q
Using of the salt
and pepper mill
j
Pull off the aroma seal cover
11
from the bot-
tom of the base with container
6
before use
(see fig. B).
j
Please keep the button
2
pushed to activate
the salt and pepper mill. The bulb
9
on the
base of the salt and pepper mill will then be
simultaneously activated.
Q
Adjusting the grinding level
j
Turn the adjustable screw
8
clockwise to re-
ceive a finer grinding level (see fig. C).
j
Turn the adjustable screw
8
anticlockwise to
