Use and maintenance manual
Press device
Model: FRA-100
__________________________________________________________________________________________________________
P a g . 7
Up the top plate using the manual valve in UP position.
-
Preparing the joint
Place the first end of the belt on the lower silicone, well centred on the support tray and making
sure the joint is within the welding zone of the hotplate.
Then place two sufficiently large scraps and the same material offered up to weld, at both ends
and properly tangential to the belt, and fix them using the same holding bar.
It is also possible to use metal callipers of the same thickness as the belt and, when necessary,
use scraps of the same belt after the callipers to fill out the welding zone.
NOTE: It is always recommendable to fill out the material, at least to 70% of the pressing
surface, to avoid deformation in the plates or thickness differences in the welding.
Afterward, insert the second end of the belt, leaving the whole surface to be joined fully in
contact with the first end already fixed, and hold it with the other holding bar.
