Use and maintenance manual
Auto-Puncher for timing belts
Model: APTM-600
____________________________________________________________________________________________________________________
P a g . 1 5
NOTE:
The programmed values will not be lost, even if the equipment is switched off. The program
always memorises the last values input.
Press START to begin cutting at the first end.
NOTE:
No programmed value may be changed during the cutting process, except the cutting time.
To do so, press STOP, change the value, and then press START to continue.
Once the first cut is completed, release the belt by pressing the bar raise button.
Place the second end of the belt by the Right side by the guide and position.
And the pencil line of the belt just by the laser mark or 1/2mm more inside depending on the
thickness belt.
