User manual P 40 - P 120
Issue: 11.14
1 General Information
Page 3
1.4. Electrical equipment
• Any work extending beyond the scope of equipment maintenance must be performed by a specialist
only.
• Always follow local- and national regulations.
• The heater must always be connected to the mains electrical supply via an earthed socket.
• Keep the socket within reach.
• Always disconnect the appliance from the mains before performing any work on it.
• Never remove the safety grill while the heater is active or could be activated.
• Before starting up the appliance, examine all electrical wiring for any visible defects.
• Change any damaged wiring before switching on the appliance.
• Never remove the plug from the socket while the heater is active.
• Always allow the heater to cool down.
• Never use the heater while any component is missing.
• Have any plug devices that are damaged or destroyed replaced by a qualified electrician.
• Do not pull the plug out of the socket by the flex.
• Covering electric motors can cause high temperatures to build up, which can destroy the electrical
equipment and cause fires.
1.5. Maintenance
Always disconnect the appliance from the mains before working on the electrical
equipment!
Repairs should only be carried out by persons who have the training, knowledge or practical experience
to ensure that the repair is done properly.
Maintenance, repair and cleaning work should only be carried out with the drive switched off and the
motor idle. The same applies to the rectification of functional defects.
Wear protective gloves if there is a danger of injuring your hands!
The user must satisfy himself that the appliance or machine has been returned to its proper state after
carrying out repair work. Technical equipment must not be re-started until all safety devices are in place.
Spare parts must at least correspond to the technical requirements specified by the manufacturer of the
equipment. This will be the case if, for example, original spares are used.
1.6. Ordering spare parts
When ordering spare parts, always indicate the following:
• Code no. and description of part or item number with description and manual number for uncoded
parts;
• Number of original invoice;
• Electricity supply, e.g. 230V, 50 Hz.