Use and maintenance manual
Manual die cutter
Model: F-121
____________________________________________________________________________________________________________________
P a g . 1 9
WARNING:
To be able to position the head in any of the three positions: ST1, DF, ST2; it is essential
that it is at the beginning of the stroke (
0
) on the right side, otherwise, we could damage
the mechanical elements of the locking cam.
We will start the cutting operation from right to left until we cut the entire width of the belt.
We will remove the waste, move the head again to the end of the stroke (
0
) and position the
head at ST2 and the
pressure regulation knob at 0
to cut the lower fabric.
We will lower the clamping bar on both sides of the bench.
We will adjust the pressure mode at the desired point and start the cut from right to left.
