www.electroreplacement.com
UK Sales & Technical Support
TEL: 01923 255 344
[email protected]
ACO Technical Support
www.support.aco.com.pl
www.aco.com.pl
UK Distributor of
ACO products
E&O.E.
PROXIMITY CARD MANAGEMENT
• The
fi
rst key fob programmed will become the Master Key Fob
(supplied and pre-programmed with kits)
• The Master Key Fob will then be used to program all
subsequent key fobs going forward
• To enter programming mode a Master Key Fob must be used
• Maximum of 10 key fobs per station
Where is the RFID Reader?
• The RFID Reader is situated directly behind Call Station 1 name
plate
Adding user key fobs
• Hold the Master Key Fob to the panel RFID Reader
• During the door opening process hold the next key fob to the
panel. (You will be automatically entered into Programming
Mode at this point)
• Hold new key fob to RFID Reader until an audible beep is heard
to con
fi
rm card acceptance
• Repeat holding key fobs to panel RFID
If an unregistered key fob is used at the panel a short triple beep sound
will be emitted
Exiting Programming Mode
• Programming Mode will time out after 5 seconds of no activity
Deleting key fobs from an allocated call station
• Hold Master Key Fob to Panel activating door unlocking process
• Immediately press and hold relevant call station for 4 seconds
• A loud beep will be emitted for about 10 - 15 seconds
• When it stops the call station has been cleared of all key fobs
including Master Key Fob
• This can be con
fi
rmed by holding Master Key Fob to the panel -
as now unregistered you will hear 3 short beeps
Deleting individual key fobs is only possible via the software
Creating a Master Key Fob
• Panel must be o
ff
• Press and hold the
fi
rst call button
• Turn power on > a loud continuous beep will sound
• Take your
fi
nger o
ff
the call button
• Hold and place an unregistered key fob to the RFID Reader
• You will hear the beep stop for a split second then a second
short beep will sound
• The Master Key Fob is now programmed
Supply voltage
15VDC ± 5%
Power consumption in standby mode
~ 2.5W
Maximum power consumption
400mA
Electric strike supply voltage
12VDC - 15VDC
Permissible electric strike output load
1.5A
Output type
Normal or reversing (default:
normal)
Lock activity time
0.6 to 25s (default: 4s)
Output control type
Pulse to the electric strike (default)
or constant to the relay
Camera angle
About 75º
Camera adjustment angle
Vertical and horizontal 20º
Connector type
RJ45 socket / removable ARK
screw connectors
Panel front material
Stainless steel
External input impedance for opening
(INPUT)
≤
20
Ω
, input type: normally open
(NO)
INPUT activation delay time
0 - 25s (default: 0s)
Panel front dimensions
286 x 90 mm (height x width)
Proximity RFID Standard
Unique 125KHzs
maximum number of supported
proximity cards 70
10 for pr 10
administrative ones
COMO PRO Technical Speci
fi
cation
Contact
your
local
wholesaler
for sales
enquires
!