www.electroreplacement.com
UK Sales & Technical Support
TEL: 01923 255 344
[email protected]
ACO Technical Support
www.support.aco.com.pl
www.aco.com.pl
UK Distributor of
ACO products
E&O.E.
Panel Installation
• The surface mounting cover protects the system from adverse
weather conditions especially water
• Setting the cameras height around 1.6m from the ground is
a good starting point, however in order to obtain the optimal
view experimenting with height and location is recommended
• Avoid locations where the camera lens is exposed to direct,
perpendicular, light rays from sunlight, street lights and other
light sources
• In order to get the best tightness it is recommended to cut out
only the holes that are necessary to mount the panel. There is
a thin foam gasket on the front surface of the
fl
ush mounted
box. Pay attention when screwing the panel front so that it
adheres to the gasket evenly and with its entire surface
Master and Secondary Panel Assembly
Connecting two panels is possible in a Master and Secondary setup
Jumper positions should be set on each panel main board:
• Master Panel: J1 Jumper = Open (Master)
• Secondary Panel: J1 Jumper = Closed (Secondary
In a Single panels installation the J1 Jumper should be set to Master:
• Secondary Audio panels can be connected directly to the +DC
Power and - DC Power GND and Line terminals
• Secondary video panels should be connected using the VIDEO-
SW2 MINI-60 camera switch
NOTES:
• The master panel always has priority of all functions, opening
doors, activate a call, standby mode
• The panel that initialises the call will automatically connect to
the caller. The receiver will only be able to unlock the door that
the calling panel operates
• If a second call is attempted from another panel while the
fi
rst
panel is in use, the caller will hear an engaged tone
Panel Volume Settings
The panel default volume settings are set at the factory but can be
easily changed using the dials situated on the panel main board.
•
MIC adjusts the sensitivity of the panel microphone
•
SPK adjusts the panel volume
•
BEEP adjusts the panel beeps
HOLE 1
Flush mounting box main wire feed
HOLE 2
Additional module slot - break o
ff
to use
HOLE 3
For mounting in a steel column or similar structure
Maximum wall thickness 32 mm - additional set of
gaskets and screws should be used
HOLE 4
Auxiliary holes are for temporary mounting, e.g.
using nails in a soft material such as Styrofoam
HOLE 5
Panel mounting holes for
fl
ush
fi
tting. Appropriate
screws, wall plugs and gypsum should be used
HOLE 6
Surface box mounting holes. Screw housing bolts
evenly into the assembly box using a 3 mm Allen
key
HOLE 7
Surface mounting box cable entry slot