#VGU120080104
- 10 -
Drwg. 1. Die replacement.
For proper performance place a set of dies in the press (two dies of the
same dimension).
4.2 CLAMPING TERMINALS AND CONNECTORS
-
Select an adequate terminal (a cable before clamping should have minimal
clearance in the cylindrical part of the terminal or connector).
-
Select a proper clamping die for a given terminal type and diameter.
-
Remove insulation from the wire or cord to allow the insertion of the wire into
the cylindrical part of terminal or connector.
-
Push the wire into the bottom of the cylindrical part of the terminal or the
connector.
-
Clamp the terminal (connector) until the dies join and until the drive overflow
valve action.
-
To obtain a proper connection follow the instructions below.
For round terminals and connectors clamped with dies
USM
. Follow the
markings on the round part of the terminal. In case there are no markings on the
terminal (connector) make a large number of clampings maintaining intervals
between the clampings (Figs. 2a and 2b). Clamping of the terminal should be
started from the tab (impression I) and continued towards the wire (impressions II
and III). Clamping of the connector should be started from its middle part
(impression I) and continued towards the wire.
