Erie water treatment IQSoft IQ-CS, Installation & Operating Instructions Manual

Page: 9 / 134

ELECTRONIC CONTROL PANEL
Page 9
EN - English

To cancel this mode, press the scroll  button
repeatedly; the control panel will return to the service
mode.
SALT LEVEL ALARM
The electronic control panel is equipped with a salt level
alarm, that will periodically remind the user to check the salt
level inside the brine cabinet and to refill it with water
conditioner salt if necessary. When the salt level alarm is
triggered, the following will happen:
1.
the backlight of the display will flash on/off;
2. the buzzer, if enabled (see Basic Settings), will beep 3
times every hour;
3. the display will show:
After refilling the brine cabinet, simply push the down

button to reset the salt level alarm. If any other button is
pushed, the salt level alarm will be cancelled, but not reset,
meaning it will be activated again after the next regeneration!
If the brine cabinet is refilled by the user with water
conditioner salt, before the salt level alarm is activated, it is
possible to reset the salt level alarm.
1.
Press the scroll

button; the display will show:

Press the down

button to reset the salt level alarm.
HOLIDAY MODE
It is possible to put the appliance in holiday mode; this will
prevent automatic regeneration from taking place, yet will
ensure the appliance is automatically regenerated at the end
of the holiday cycle.
1.
Press the scroll  button repeatedly until the display
shows:

Press the up  or down  button to activate the
holiday mode by setting the number of full days away
from home, or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:

The holiday mode is automatically cancelled when a
regeneration is manually initiated!
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll  button and hold it for 2 sec until the
display shows:

Press the up

or down

button to set the
language.
2.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the time of
day.
3. Press the scroll  button again; the display will show:

Press the up  or down  button to set the unit of
measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the hardness
of the incoming untreated water.
5. Press the scroll

button again; the display will show:

Press the up

or down

button to enable the
buzzer by setting the sound level, or disable the buzzer
(OFF).
6. Press the scroll

button again; the display will show:

Press the up  or down  button to save the settings
into the NOVRAM® and exit the programming mode.
Check salt level
To reset push

Salt Added?
To reset push

Holiday: OFF
Language:English
Set time: 8:01
Set hardn: XX °f
HardUnit: °f
Exit
8:01 Holiday
TotVol: 1234567L
Buzzer: 2