PRECAUTIONS
Page 4
Make sure to adhere to the following precautions before and during service of the appliance:
•
Before disassembling any parts from the appliance, make sure to disconnect the power
supply to prevent any damage caused by short circuit.
•
Before disassembling any hydraulic parts from the appliance, make sure to:
➢
put the appliance hydraulically in bypass,
➢
release the pressure from the appliance.
•
The appliance contains small parts that may fall out when disassembling the appliance.
•
Screws:
➢
Whenever reinstalling a screw into a plastic material, make sure not to damage the
original screw thread; before tightening the screw, turn it counter clockwise slowly,
until you feel the screw dropping in place in the original thread.
➢
Whenever a part is fixed by means of multiple screws, always tighten the screws
evenly in a cross pattern.
•
O-rings & gaskets:
➢
Never remove an O-ring or gasket using a sharp tool, to prevent damage to the O-
ring or gasket.
➢
When reusing an O-ring or gasket, gently clean it with a clean rag or piece of tissue
and make sure it is not damaged before reinstalling.
➢
Before installing an O-ring or gasket, clean the groove or seat of the O-ring or gasket
and the corresponding sealing surface.
➢
Before installing an O-ring or gasket, lubricate it by means of:
o
for dynamic seals on moving parts: food grade silicone grease, to facilitate
the assembly/insertion of the part and to reduce the friction of the
movement during operation;
o
for static friction-free seals on non-moving parts: a bit of water, to ensure a
better water tight seal.
Summary of Contents for IQsoft IQ-CS-12
Page 15: ...Page 15...
