Quick Start Guide: Connect-Power-Configure
4. During initialization, confirm that the
Status
LED is on and all
Up
,
Down
,
Left
,
Right
,
Edit
and
Save
pushbuttons are lit.
3.2.2
Power Up Operating Modes
When the equipment is switched on it will assume the control mode that was set
when the power was turned off.
3.3
Configuring the Inputs
3.3.1
Transport Stream (ASI) Input
To configure the unit for ASI input:
1. Select
ASI
input from sub-menu
2.1Select Input
.
3.3.2 8-VSB
Input
To configure the unit for a Vestigial Sideband (VSB) modulated input:
1. Select
VSB
input from sub-menu
Select Input
.
2. Select channel/frequency from the sub-menu
8VSB
.
3. Select Direct Frequency/Auto Tune enable/disable from sub-menu
8VSB CTRL
.
3.4
Selecting a Decode Service (Program)
To select a decode service:
1. Navigate to the
Service
menu. For incoming feeds containing only a single
service the service may be selected automatically depending on service
selection control.
2. If the service is NOT selected, press
Edit
and, using the
S
(Up) and
T
(Down)
pushbuttons in the decode service sub-menu, scroll through the service name
list.
3. Press
Save
to select the required service.
Note:
If the unit has successfully selected a service, then the Service ID and
Service name should be displayed in the
Service
menu.
3.5
Configuring the Video Output
When configuring the Video Output, the following points should be observed:
EN/LZT 790 0008/2 R1A
2011-03-30
11 (36)
