Quick Start Guide: Connect-Power-Configure
3
Quick Start Guide: Connect-Power-Configure
3.1
Connecting the Receiver
The following points should be noted when making signal connections to the
receiver:
•
If you have an incoming 8VSB feed, this should be connected to the rear panel
connector marked
RF INPUT
.
•
If you have an incoming ASI feed, this should be connected to the
ASI Input
.
•
Decoded PAL or NTSC video is output on connector
CVBS
.
•
Decoded analogue or digital audio is output on connectors
AUDIO OUT 1
or
2
.
Adaptor cables are used to provide the connector type required for the
installation.
•
The incoming feed is routed through the unit and output on connectors
ASI OUT
1
or
2.
•
If the unit is to be controlled by Web browser or PC based control system then
the control PC should be connected to connector
ETHERNET 1
or
ETHERNET
2
.
3.2
Powering the Receiver
3.2.1 Switching
On
Caution!
This equipment should not be operated unless the cooling fans are working and
there is free-air flow around the unit.
1. Connect all signal and power cables to the rear panel of the unit.
2. Switch on the AC power supply to the unit at the wall or rack outlet.
Note:
The RX8320 Receiver does NOT contain a power on/off switch.
3. After a short period of initialization the following screen is displayed on the Front
Panel:
INITIALIZING
4.3.2 (Bank 0)
EN/LZT 790 0008/2 R1A
2011-03-30
10 (36)
