Control Unit And Mic Hangar Installation
Refer to Figure 10 for a detailed mechanical drawing of the control unit
and microphone mounting assembly. The mounting bracket shown mates with
the Harley-Davidson Road King hardware. For all other models, an additional
adapter bracket is required.
1.
Using the hardware supplied (part of Hardware Kit 350A1396G3), mount
the control unit bracket to the motorcycle.
2.
Mount the control unit and mic hangar to the mounting bracket.
After installing the control unit, do not make any cable connections until
all cables have been run and secured. Speaker and option connectors are shown
on the Interconnection Diagrams listed in the Table of Contents.
SPEAKER MOUNTING
Mount the speaker where the operator can hear it, and where it does not
interfere with the safe operation of the motorcycle. On some motorcycles, the
speaker can be attached to the windshield bracket using existing bolts to secure
the speaker mounting bracket (see Figure 11).
Be careful to avoid damaging some vital part of the motorcycle if it
becomes necessary to drill mounting holes. Also, always check to see how
far the mounting screws will extend below the mounting surface before
installing. Caution must be exercised to not drill through the gasoline tank.
CAUTION
A special spacer may be required between the control unit bracket and the
motorcycle to raise the level of the control unit bracket. This spacer, if
needed, must be constructed locally.
NOTE
20
Figure 12 - Option Cable Stored Beneath Saddle Area
Figure 13 - Triangular Frame Assembly
25
Summary of Contents for ORION
