Ericsson ORION, Installation Manual

Page: 18 / 44

Figure 7 - Case Mounting Bracket And Case Assembly
Figure 8 - Radio Connections
18
3. Before replacing the fairing, the control cable and any option cables may
be run under the fairing also. Replace the fairing by removing the gas cap,
repositioning the fairing, then replacing the gas cap and the screws that
secure the fairing.
For motorcycles not equipped with a gas tank fairing.
After making power connections, run the control cables up the left side of
the motorcycle to the control unit and secure the cables with the cable ties. All
cables connect to the back of the control unit.
Cable Connections
Cable connections consist of connecting the power and control cables
(individual red + and black -), the radio control cable, and the antenna cable.
Verify that all cables have been connected and are secure.
Refer to control cable assembly drawings 19B802554 and Interconnection
Drawings 188D6783 for all electrical and mechanical application details.
Power Cable (19B802622P2, USA Version)
As shipped from the factory, the power cable is equipped with a 12 ampere
in-line fuse (installed) and ring terminals. The power cable supplies power
from the battery to the radio. Refer to Figure 8, Radio Connection. Note: The
European Version Power Cable, 19B802554P25, is a combined cable
containing both the power and control cables.
1. Connect the red lead (+) to the battery terminal on the alternator whine
filter and the black lead (-) to ground on the alternator whine filter.
2. Route the cables to the battery and then connect the black (-) and the red
lead (+) to the battery terminals.
It may be necessary to notch a portion of the fairing at the control unit end
and at the saddle area to provide entrance and exit holes for the cable. The
entrance and exit cutaway holes are required to permit the fairing to be
remounted flush to the gas tank.
NOTE
27